Instrumentation and SCADA · Signals and Basic Control
What Is an Analog Signal?
An analog signal changes smoothly as the measured condition changes.
A common plant signal represents the low end and high end of an instrument range. The exact signal standard and scaling are set by the plant. Operators should use the loop information provided for their facility.
If tank level rises smoothly but the displayed value stays fixed, the loop may be frozen, disconnected, or held in a manual state.
An analog loop represents many values between its low and high ends. The receiving device must use the same scale as the transmitter. If one end is set for a different range, the display may be wrong even though the signal is healthy. Operators may notice this after a replacement or programming change. Compare known process points when possible. A reading that is always off by the same amount may suggest a different problem than one that is off by a percentage.
A scaling mistake can create a smooth, believable, but completely wrong value.
Key point: If the receiving device uses a different scale than the transmitter, the display can be wrong even though the signal is healthy.
Keep learning
Wastewater Instrumentation, SCADA, and Process Control Fundamentals
This page comes from the course. It covers plant instruments, signals and control, flow, level, pressure and water-quality measurement, SCADA and alarms, and instrument maintenance, one step at a time, with short knowledge checks and a certificate of completion.
Take the course