Lift Stations · Lift Station Purpose and Types
What Is a Submersible Pump Station?
A submersible pump is designed to operate while covered by wastewater. At many stations, the pump slides down guide rails and connects to a discharge fitting near the bottom of the wet well.
This arrangement removes the need for a separate dry pump room. The motor and pump remain below the liquid surface, while controls and electrical connections are placed in accessible equipment areas.
A lifting chain or cable is not permission to pull a pump without planning. Pump removal may involve stored pressure, electrical energy, heavy suspended loads, contaminated surfaces, and an open wet well. Follow plant procedures, lockout/tagout, and approved lifting practices. Lockout/tagout is the program that shuts off and locks out energy so equipment cannot start or move during work.
Operators inspect accessible cables, rails, lifting equipment, hatches, controls, and run data. Pump removal is performed only by trained staff using rated equipment.
Key point: Submersible stations simplify the layout but still require strict control of energy, lifting, and wet-well hazards.
Keep learning
Lift Stations for Wastewater Operators
This page comes from the course. It covers pumps and level controls, inspections, alarms, power and bypass pumping, clogs, gas hazards and overflow response, one step at a time, with short knowledge checks and a certificate of completion.
Take the course